Hack Squat

🎯 Quadriceps🏋️ MachineBeginnerCompoundCalves (2°)Glutes (2°)Hamstrings (2°)

How to do the hack squat

  1. Place the back of your torso against the back pad of the machine and hook your shoulders under the shoulder pads provided.
  2. Position your legs in the platform using a shoulder width medium stance with the toes slightly pointed out. Tip: Keep your head up at all times and also maintain the back on the pad at all times.
  3. Place your arms on the side handles of the machine and disengage the safety bars (which on most designs is done by moving the side handles from a facing front position to a diagonal position).
  4. Now straighten your legs without locking the knees. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances described in the foot positioning section).
  5. Begin to slowly lower the unit by bending the knees as you maintain a straight posture with the head up (back on the pad at all times). Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
  6. Begin to raise the unit as you exhale by pushing the floor with mainly with the heel of your foot as you straighten the legs again and go back to the starting position.
  7. Repeat for the recommended amount of repetitions.

Muscles worked

The prime movers are the quadriceps across the front of the thigh, which straighten the knee and, just as importantly, control it on the way back down.

Because more than one joint is moving, the work does not stay in one place: the calves control the ankle and hold the heel position; the glutes finish hip extension; the hamstrings assist hip extension and slow the knee down.

Every exercise for:QuadricepsCalvesGlutesHamstrings

How this movement works

The working muscles shorten as they drive the load away from you, and more than one joint changes angle to do it. Load spreads down a chain instead of sitting on one muscle, which is why a compound push handles more weight than any single-joint alternative — and why joint position, not the muscle, is usually what fails first.

It is filed under strength: produce force against resistance for a countable number of repetitions, and progress the resistance over time.

What you need

The machine fixes the path, removing the balance demand and letting you train close to failure without a spotter. The cost is the stabilising work a free weight would have made you do.

Every exercise using:Machine

These train the quadriceps too, using equipment this one does not:

Difficulty

Listed at beginner level: the pattern is simple enough to pick up without coaching, and a position that goes wrong mid-set is obvious enough to correct on the next repetition.

Of the 173 quadriceps exercises in this database, 70 are listed at beginner level.

Related exercises

Photos: free-exercise-db — public domain (Unlicense) Full attribution →

ⓘ Informational only — not a substitute for professional fitness or medical advice.